UPC: 0843441101970 | POWERTEC 80005 L-Shaped Square 3PK Set with Levels 5 8” 14” in Length – Premium Aluminum- Standard and Metric Index – The Ultimate Gift for any Woodworking shop

UPC lookup results for: 0843441101970 | POWERTEC 80005 L-Shaped Square 3PK Set with Levels 5 8” 14” in Length – Premium Aluminum- Standard and Metric Index – The Ultimate Gift for any Woodworking shop

Introducing the L-Square Set with Levels by POWERTEC Make sure you re in square with this exclusive square level set; it s your handy measurement solution for accurately determining and marking the level square-ness in your projects. With clearly marked scales (in both inches and mms) along with built-in neon green easy-view bubble levels (1 long) these L squares help you get the job done to perfection quickly and easily. Ideal for use in your rafter roofing deck and stair applications and so much more. Comprised of three of the most popular sized rulers (5 8 14 ) for the utmost in versatility and convenience. Streamline your productivity and enhance your woodworking enjoyment; satisfaction squared. For professionals and DIY’rs alike there’s no end to the uses of this essential dead-on square measurement instrument. It’s a top industry choice for ensuring highly efficient and accurate productivity. Determine if your projects are in square and your angles are accurate with this handy tool; for precision measuring and marking Handy 3PK set includes three popularly-used square sizes: One each of 5 8 14 in length Constructed of premium anodized aluminum for durability and wear and rust-resistance Scale is clearly marked in both inches and mms Neon green bubble levels (1 long) allow for quick and easy level-determination and adjustment The squares are factory set if after checking you find them to be out of square the two large squares are adjustable and can be reset. Use a square or set block of known accuracy to check the larger squares for perpendicularity. If not perpendicular loosen the screws on the handle and adjust until the ruler is perpendicular to the square. While holding the ruler against the square tighten the screws. If there is no square available the right angle accuracy can be checked by using the factory edge of a board. Using the factory edge draw a line and then flip the square ruler over and draw the same line from the other direction. If the 2 lines are apart use a 3mm wrench to adjust the angle. Repeat the steps until the 2 lines overlap.